This step isn't really necessary, but it does make the parameters easier to work with. The first step to perform is to edit the shaft part, and rename the parameters that define the shaft diameter. I'll use parameters to like the diameter of the bore to the diameter of the shaft. Looking at the image below, it's easy to tell that the clearance is far larger than. ![]() I'm purposefully keeping the clearance large so the change is easier to see. The shaft has a dimension that may vary, but I know the corresponding bore has to be. ![]() It's been several years since I had used this method, but in short, yes it can be done, and this is how to do it.įirst, I have two parts, a shaft, and a base that contains a bore shown in an assembly file. Last week, I was asked "Can you link parameters from one part to another in Inventor?" “New links must be forged as old ones rust”
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |